This video will show you how to change the gas on a Troy-Bilt riding mower. Depending on your model, the instructions in this video may vary slightly. Always be sure to check your operator's manual for detailed instructions.
Instructions
Step 1
Place your mower on a flat, level surface. Turn the mower off. Make sure the engine is cool. Remove the ignition key and disconnect the spark plug ignition wire.
Step 2
Unscrew the gas cap.
Step 3
Using the Arnold Siphon Pump, place the top port into the gas tank on the engine, and the bottom port into a proper container.
Step 4
Prime the pump by pumping the handle three to four times. Once the liquid begins to flow, it will flow without further pumping.
Step 5
Remove the Arnold Siphon Pump and add new gas.
Step 6
Replace the gas cap.
Step 7
Reconnect the spark plug ignition wire.
Step 8
Dispose of the gas properly.
